Hi,

I recently got all my MOTUC figures out of storage to display and noticed Teela has a real bad case of bobble head syndrome. Her head doesn't seem to go any lower on the neck peg no matter how much I try to heat it or push it on. Are all the Teelas like this?

I've tried dremeling into the head socket to make the cavity deeper, but it hasn't helped much.

Should I dremel more out or is this just how the figure is?

If anyone has managed to remedy this, I'd like to know how you did it.

Thanks,

Ad

mine has the same problem. I took a very small piece of paper and folded it a few times and shoved it between her neck and her chin behind her face. that made it tight and held her head looking out instead of looking down